Custom Screw Down Collars and Bracelets

You thought you had seen all there was to see in the world of manacles and Collars. Well, Try this on for size,

Solid Seamless Sterling Collars...., No Hinge.

These pieces are custom sized to your anatomy. Made of Sterling Wire/Sheet, the two halves are held together with Industry Common Hardware (i.e.: machine screws). This hardware will come in Stainless Steel unless otherwise specified or requested. A leash attachment may be added as an option to some of these designs for an additional fee. If you want a little more security or permanence, I am starting to offer Security-One-Way Screws as an option. These screws will only go in, and are very difficult to remove.

Screw Down Collar

    Introduced on 11-20-99, this Collar is made of a single piece of Solid Sterling Domed Stock (6mm Width shown), held together by two "Button Head Cap Screws". The screws are removed with an Allen wrench. The 8mm and 12mm versions are also available with a loop for a leash or padlock, at an additional cost.


Lets Talk About Options

BASIC LOOP BEAD LOOP
ONE-WAY SCREWS SPANNER SCREWS
JINGLE BELLS ENGRAVING


12mm w/Button Head Screws 6mm w/Spanner Screws


Sterling Collars & Manacles
6mm Wide Collar = $105 +(s&h)
8mm Wide Collar = $125 +(s&h)
12mm Wide Collar = $145 +(s&h)

6mm Wide Manacle = $60 +(s&h)
8mm Wide Manacle = $65 +(s&h)
12mm Wide Manacle = $70 +(s&h)

*Notes:

  • Collars Bigger than 17" will be slightly more expensive due to extra metal needed.
  • Prices subject to change without warning due to metal market fluctuations.


10k, 14k, & 18k Gold Collars & Manacles

Thanks to one of my customers in England, I have this lovely picture of a 6mm 10K Gold Collar w/Button Head Screws. For a larger version Click Here!


6mm 10K Gold Collar w/Button Head Screws


8mm 10K Gold Collar w/Button Head Screws

10k, 14k, & 18k Gold Prices

6mm Wide Collar = email
8mm Wide Collar = email
12mm Wide Collar = email

6mm Wide Manacle = email
8mm Wide Manacle = email
12mm Wide Manacle = email





Taking Measurements:

I suggest that my clients use either a dress-makers tape measure or even a piece of string. First measure the circumference around the neck, then begin to loosen the loop till you have the amount of play that feels comfortable (generally between 1/2" to 1-1/2" larger than the neck). Send me this measurement.

Or, if the wearer is going to be wearing clothing like turtle-neck shirts and you want to wear this collar on the outside, then have the wearer put on a turtle-neck, and take the measurement with the shirt on.

These are my common suggestions. In the end the fit of the collar is up to you or the wearer.

*Note: Measurement may be in Metric or Inch Standards.







[Back to Collar Creations]

Jewelry Page